Compared with previous years, the current electrical connection mode has undergone a qualitative change. Peeling - merging wires - wrapping tape is a routine operation of early wiring. If a large number of wires are to be connected, it will waste a long time, and this wiring style makes maintenance difficult; Now, once the cold pressed terminal is pressed, the conductor is inserted, and the terminal block is connected, the operation can be completed. It is equipped with a manhole, which provides great convenience for later maintenance.

The road gate controller is an intelligent multi-function manual and wireless remote control equipment designed with digital technology. It has good intelligent judgment function and high reliability, and is the first choice of automatic control equipment in the current electric road gate system.

The track brake control board controls the motor to reverse in the forward direction according to the operation command. The motor drives the input shaft of the reducer to rotate. The reducer then decelerates the output shaft and drives the rocker arm to rotate up and down 180 ° in the second half cycle. The reducer rocker arm drives the drive arm to move up and down 90 ° in the second half cycle through the lower joint bearing, the connecting rod, and the upper joint bearing. The spindle drive arm drives the brake rod connected to the spindle to move up and down 90 ° horizontally and vertically.

The switch operation of the controller includes high and low sensitivity, vehicle passing and falling pole, counting falling pole, anti-collision rebound, normal operation mode, automatic control mode, etc. The internal connection of the controller needs to operate in coordination with multiple terminal blocks.

Terminal blocks are commonly used connectors in electrical equipment, which play a role in the connection process. The gate control panel is usually a PCB board, and most of the required terminals are commonly used LC plug and pull series: the socket is welded on the PCB panel, and the plug is directly inserted into the socket to complete the wire connection after the wire is connected. After the wire is inserted into the plug, pull it outward to see if the wire is firmly connected, if the wiring is too shallow or if the wire is not compressed. After the inspection, you can use it with confidence.

The connection terminal link is a link that looks very simple but is prone to problems. When the circuit is blocked or the machine cannot run, the terminal connector should be checked first. Therefore, it is very important to check the quality of terminal blocks. Zhejiang Feide Electric Technology Co., Ltd has always taken excellent quality as its reputation, and has accumulated nearly 20 years of industry experience. Starting from serving the fundamental interests of customers, it has practically solved the difficulties and pain points in the installation process of customers, and strives to be a long-term partner of customers.